E80/E70 Digital Electrocardiograph User’s Manual
4-1
Chapter 4 Operation Instruction
This manual is based on the maximum configuration, you can choose the
configurations you need. Therefore some contents may not apply to your
product which will display gray on your product and are useless for users.
4.1Turn On/Off
Using AC power supply:
——Turn on: Press the power button after connecting the power cord. the
screen displays the start menu, and then enter work mode.
——Turn off: Press power button, and screen will display “Power off…”,
when the prompt info is over, the device is power off. Then unplug the power
pin.
Note: When powering off is not work, pressing power button lasting
5s can force to turn off.
Using battery:
——Turn on: Press the power button, the screen displays start menu, and then
entering work mode.
——Turn off: Press power button, and screen will display “Power off…”,
when the prompt info is over, the device is power off.
Warning:
Advert to status of patient and device at any moment;
If the electrocardiograph is mechanically damaged, or if it is not
working properly, do not use it for any monitoring procedure on a
patient. Contact your service personnel.
4.2 Patient Info Setup
Press【Patient info/F1】 in main interface to enter patient info setup
interface. Shown as following chart.
To Next Page
Loading...