E80/E70 Digital Electrocardiograph User’s Manual
4-9
This is mainly readjusting report format stored in “Auto” mode. The
selected box is failed to use while report stored is not “Auto” mode.
4.5 Work Mode Setup
Pressing “ Mode ” on keyboard in main interface can switch
electrocardiograph’s work mode.
Work mode contains: Auto mode, Manual mode and Rhythm mode.
You can set work mode parameters by selecting “Work mode/F1” in main
interface.
4.5.1 Fast Mode
Fast Mode is a real-time sample mode which only support the fast style
of 12×1.The device will output the waveform as soon as the user press
“Record/Stop” key on keyboard. The waveform and diagnosis information
will be recorded on the same paper.
For the operations in details, please refer to the following steps:
1. Before recording, enter the patients’ info.
2. Press the “Mode” key on keyboard to switch the working mode into Fast
mode.
3. Select 【Working mode/ F1】 key to conduct setup properly, including
Fast style, Recording time, Lead sequence and Channel lead, and select
【OK】, as shown in Fig. 4-10 below.
4. Press “Record/Stop” key on keyboard to start recording. The machine
will stop automatically after a complete ECG diagram is recorded.
During ECG recording in Fast mode, if the user has set the paper
moving speed of recorder at 50mm/s,25mm/s or 12.5mm/s, the waveform
of 2.5s, 5s and 10s will be output separately. The diagnosis information
will be output after analyzing completely. If you want to output all of the
waveform datum, just press the “Copy”key on the keyboard.
To Next Page
Loading...