Patient Monitor User’s Manual
5-12
can set the HR uplimit and downlimit. Attention: The high alarm
should greater than the low one.
5.6.3 Setting ECG Scan Speed
Select scan speed of ECG waveform. Click the right of
【Speed】, you can select “6.25 mm/s、12.5mm/s, 25 mm/s”.
5.6.4 Setting ECG Gain
Select the gain item of ECG waveform. Click the right of
【ECG Gain】, you can select “2.5 mm/mV、5 mm/mV、10
mm/mV”.
5.6.5 Setting Lead Type
Select the lead type of ECG input.
z If the monitor only has 3 lead, you can select “3 lead” as
lead type.
z If the monitor has 3 lead and 5 lead, you can select “3 lead”
or “5 lead” as lead type.
5.6.6 Setting Primary Lead
Select the ECG waveform, and this lead is the key
monitoring lead。
To Next Page
