22
Before Getting Started
23
Before Getting Started
V. BEFORE GETTING STARTED
CHARGING BASICS
Before using the system for the first time, charge the receiver for a complete charging cycle without
interruption. A transmitter charger is supplied along with your transmitter package. Rechargeable
transmitters must be fully charged each time you start a new monitoring session. Otherwise, your
sensor will likely not remain operational until the end date of sensor wear period (14 days).
A complete charging cycle of the receiver takes about 4 hours. For the transmitter it takes about 2
hours when using the supplied USB adapter plugged into a standard household electrical outlet
(100 to 240V AC, 50/60 Hz). It is recommended to use only the supplied USB cable and USB power
adapter.
CHARGING THE RECEIVER
WARNINGS :
Not Getting Urgent Alarm/Alert. There are no alarm/alerts, when your receiver is turned off or
its battery is dead.
PRECAUTIONS :
Plug in to Charge. To best protect yourself from not getting the alarm/alerts due to a depleted
battery, plug in your receiver to charge at the end of the day and charge it up overnight.
Confirm Charging Status Instability of power resource may cause missing of charging icon.
Check the status of charging by the battery status icon (charging or discharging) is displayed
in the top-right corner of the screen. When the receiver is plugged in, you should see lightning
bolt in the middle of the battery icon.
Prevent Operation during Charging Operation during charging may bring risk.
To Next Page
Loading...
