44
Set Up Your RIGHTEST CGMs
Follow these steps to apply your sensor
1. Wash your hands and wipe them with clean cloth thoroughly.
2. Choose an insertion site on the upper arm where has an adequate amount of subcutaneous fat.
Wipe the insertion site with an alcohol wipe and wait approximately for 2 minutes until the site
dried out thoroughly before getting started.
3. Open the sensor inserter package by peeling Tyvek
®
(the sealing paper) off completely. Take
out the sensor inserter from its package and keep the package until sensor session ends. Open
the sensor inserter cap.
4. Place the inserter over the site and push down firmly to insert the sensor. Stay for 10 seconds to
ensure the adhesive patch is fully attached to your skin.
NOTE :
Washing insertion site using a plain soap, drying, and then cleaning with an alcohol wipe
before insertion of a sensor help remove any oily residue and let the sensor stick properly. If
needed, consider shaving the area for insertion to help the sensor sticks securely.
NOTE :
Apply the inserter immediately after opening its package and the cap.
If you find it difficult to insert the sensor into the back of your upper arm by yourself, ask others
for assistance.
Do not push down the inserter until it is placed over the insertion site. If the insertion is not
successful or causes any discomfort, please consult your healthcare professional and use a
new sensor.
Do not apply the inserter if the sensor falls out when opening the cap and do not put the
sensor back.
Do not apply the inserter if it is misused before the insertion.
2 3 4
45
Set Up Your RIGHTEST CGMs
PRECAUTIONS :
Check the Package. Check the package of sensor inserter before opening the package. Do
NOT insert the sensor if its sterile package is damaged, broken, or unsealed before you open
the package, because it may cause infection.
Check the Expiry Date. Discard and do NOT use the sensor or sensor inserter after pasting
the expiry date in YYYY-MM-DD (Year-Month-Day) format labeled on Tyvek
®
(the sealing
paper).
To Next Page
Loading...
