BionX RIDE+ - RIDE+ Pro Controller Advanced Functions

2
1
3
4
EN-20
ENGLISH
InstruCtIons for use
• Mountain mode
The“MountainMode”allowsforlongeruphillridingbeforethemotorshowspowerreductiondueto
so-called“temperature-derating”.As“MountainMode”limitsthemaximummotortorquethemotor
willstaycoolerforalongerperiodoftime.Selectthisoptionbygoingtoassistancelevel4andthen
press-and-holdthe‘+’buttonfor2seconds.Toreturntoassistancelevel4,pressthe‘-‘buttononce.
• Changing the language option of the controller
The RIDE+ Pro controller allows you to change the language that is displayed on the screen.
See the part ‘programming’ later in this manual to set the correct language.
• Removing and installing the RIDE+ Pro controller
To remove the RIDE+ Pro controller from the bike, press the catch of
the holder and slide the controller off towards the rear. To install the
RIDE+ Pro controller onto the handlebar, align the controller with its
clamp and slide the controller forward until it clicks.
NOTICE. To prevent loss of riding information, please make sure that
the controller is switched Off before it is removed from the bike.
• Unintended removal of controller out of its dock
Ifthecontrollerismovedoffitsclampwhilethesystemisactive(‘On’),thesystemwillnolonger
assist, even when the controller is replaced into its clamp. Please select the correct level of
assistance again to reactivate the system.
• Using the RIDE+ Link
MostbikeswiththeRIDE+Procontrollerareequipped(orcanbeequipped)
with the RIDE+ Link.
This device is mounted either the right or left side of the handlebar and can
be used to regulate the following functions without moving your hands off
the handlebar:
1. ‘ , ‘ button SwitchlightOn/Off
2. ‘+’ button  Increaseassistlevel(ordecreaseregenerationlevel)
3. ‘-‘ button  Decreaseassistlevel(orincreaseregenerationlevel)
4. Throttle button For Pedelecs: walkassistupto3or6km/h(pedalingnotneeded)
For fast E-bikes:assistupto25km/h(pedalingnotneeded)
The red throttle button on the RIDE+ Link remote is a convenient help to move the bike without
pedaling(upto4km/h)walkingnexttotheE-bike.
WARNING. Beware of unintended use of the throttle button when the system is switched On.