Page 8
nGEN™ Pump User Manual
Note: If you are using a Stockert generator, connect one end of the Stockert generator-to-
COOLFLOW™ Pump adapter (39D-60X) to the Stockert generator and the other end to the nGEN™
Pump cable adapter (M581505). Connect the other end of the nGEN™ Pump cable adapter to the
COMM socket on the back of the pump. Contact a Biosense Webster representative for further
information.
When the pump identifies that a generator is connected, the cable connection indicator
appears in the upper left corner of the screen. When communication is established between the
pump and a generator that supports automatic pump control, the automatic control indicator
appears in the upper left corner of the screen. If communication is lost between the pump and the
generator, the indicator disappears from the screen and the pump emits a short beep.
AVISO: Este es un documento controlado, confidencial, y con derechos reservados. Revisar si es la revision mas actualizada.
WARNING: This is a controlled proprietary and confidential document. Verify revision is current prior to use.
Release Date: 2/14/2024
To Next Page
Loading...