Biosense Webster nGEN - Operating, Storage, and Shipping Specifications; EMC Information and Technical Description

To Next Page

To Previous Page

Page 21

nGEN™ Pump User Manual

12.2 Operating, Storage, and Shipping Specifications

Minimum Maximum

Operating Specifications

Ambient temperature 10°C 40°C

Relative humidity 10% 90%, non-condensing

Atmospheric pressure 700 mbar 1060 mbar

Storage Specifications

Ambient temperature -30°C 65°C

Relative humidity 0% 90%, non-condensing

Atmospheric pressure 500 mbar 1060 mbar

Shipping Specifications

Ambient temperature -30°C 65°C

Relative humidity 0% 90%, non-condensing

Atmospheric pressure 500 mbar 1060 mbar

12.3 EMC Information and Technical Description

The use of accessories and cables other than those specified in this user manual or specified by

Biosense Webster may result in increased emissions or decreased immunity of the pump.

The pump is intended for use in the electromagnetic environment specified in Table 7 through Table

10. The user of the pump should ensure that it is used in such an environment.

A false bubble alarm might occur if the pump is operated in an environment where the

electromagnetic disturbances exceed those specified in the tables below. For information on alarms,

see 10.10, Alarms.

Table 7 – Electromagnetic Emissions

Emissions Test Compliance Electromagnetic Environment –

Guidance

RF emissions CISPR 11 Group 1 The pump uses RF energy only for its

internal function. Therefore, its RF

emissions are very low and are not likely to

cause any interference in nearby electronic

equipment.

RF emissions CISPR 11 Class A

The pump is suitable for use in

establishments other than domestic and

those directly connected to the public

low-voltage power supply network.

Harmonic emissions IEC 61000-3-2 Class A

Voltage fluctuations/flicker emissions

IEC 61000-3-3

Complies

WARNING: This is a controlled proprietary and confidential document. Verify revision is current prior to use.

Release Date: 2/14/2024