Configures the sweep stop frequency or the frequency span of
the sweep output.
Configures the sweep start frequency or the center frequency.
Selects the sweep source.
Internal source: Selects to output a trigger signal at the start
of a sweep operation.
External source: Selects to use rising or falling edge from an
external trigger for sweep operation.
Selects between linear or logarithmic sweep operation.
Selects the sweep direction
Manually triggers the sweep operation if the source is set to
manual.
Configures the burst period.
Configures the start phase of the burst output.
Selects to burst by number of cycles or selects for external
gated burst.
Selects the source for burst output or selects the polarity for
external gated burst output.
Selects signal triggering on rising or falling edge.
Configures number of cycles for burst or infinite burst
(external source only).
Configures the delay of each burst.
Selects the type of files for save/recall.
Selects to browser through folders or files on display.
Saves the selected file into internal or external USB flash
memory.
Recalls the selected file from internal or external USB flash
memory.
Select to delete the selection.
Selects to toggle ON/OFF a DC output. Selectable DC voltages
are: 1 V, -1 V, 2 V, -2 V, 5 V, -5 V.
Selects the remote interface. .
Load – Select output impedance.
Normal/Invert – Select to toggle between normal and
inverted output.
CHCopy – Copy channel settings between channels.
Sync – Select to enable/disable synchronization output with
respect to either channel 1 or 2.
Selects built-in counter function.
Access to system settings.
Built-in self test and adjustment options.
Shows information about the generator.
To Next Page
Loading...
