46
Query syntax: LIST:TIMEr? <NR1>
Return parameters: <NRf>
Example: LIST:TIME 1,3 //set the first step’s time to be 3 S
LIST:TIME? 1 //query the first step’s delay time
LIST:LOAD
This command can recall the list file saved before from specified memory region. Sending query
commands can inquire which group file you have recalled.
Command syntax: [SOURce:]LIST:LOAD[:IMMediate] <NR1>
Parameters: 0 to 9
Query syntax: LIST:LOAD[:IMMediate]?
Return parameters: <NR1>
Example: LIST:LOAD 1
LIST:REP
This command can set the repeat count of LIST steps.
Command syntax: [SOURce:]LIST:REP <NR1>
Parameters: 1-65535
Query syntax: LIST:REP?
Return parameter: 1-65535
LIST:SAVE
This command is used to save the list file in non-volatile memory.
Command syntax: LIST:SAVE <NR1>
Parameter: 0 to 9
Return parameter: <NR1>
w ww . . co m
information@itm.com1.800.561.8187
To Next Page
Loading...
