Black Box LPB2810A - RADIUS Details

724-746-5500 | blackbox.com
Page 194
724-746-5500 | blackbox.com
Chapter 4: Security
- Disabled: The server is disabled.
- Not Ready: The server is enabled, but IP communication is not yet up and running.
- Ready: The server is enabled, IP communication is up and running, and the RADIUS module is ready to accept accounting
attempts.
- Dead (X seconds left): Accounting attempts were made to this server, but it did not reply within the configured timeout. The
server has temporarily been disabled, but will get reenabled when the dead-time expires. The number of seconds left before
this occurs is displayed in parentheses. This state is only reachable when more than one server is enabled.
• Auto-refresh: Check the auto-refresh box to set the unit to refresh information automatically.
• Icon, upper right of screen (Refresh): Click to refresh the RADIUS Status information manually.
4.6.3 RADIUS Details
This section shows you a detailed statistics of the RADIUS Authentication and Accounting servers. The statistics map closely to
those specified in RFC4668 - RADIUS Authentication Client MIB.
Web Interface
To configure a RADIUS Details Configuration in the Web interface:
1. Specify which port you want to check.
2. Check “Auto-refresh.”
Figure 4-20. The RADIUS Authentication Statistics for Server screen.
Parameter Description
• Auto-refresh: Check the auto-refresh box to set the unit to refresh information automatically.
• Icons, upper right of screen (Refresh, Clear): Click to refresh the RADIUS Statistics information manually; click Clear to clear
all new entries.
LPB2810A