Black Box ServSwitch DKM FX - 1 Specifications; Interfaces; DVI-D Single Link; Usb Hid

Page 11
724-746-5500 | blackbox.com
Chapter฀1:฀Specifications
1.฀Specifications
1.1฀Interfaces
1.1.1฀DVI-D฀Single฀Link
The video interface supports the DVI-D protocol. All signals that comply with
DVI-D single-link standard can be transmitted. This includes, for example, monitor
resolutions฀such฀as฀1920฀x฀1200฀@฀60฀Hz,฀Full฀HD฀(1080p),฀or฀2K฀HD฀(up฀to฀2048฀
x 1152). Data rate is limited to 165 MPixel/s.
1.1.2฀USB฀HID
Devices with USB HID interface support a maximum of two devices with
USB HID protocol. Each USB HID port provides a maximum current of 100 mA.
Keyboard
Compatible with most USB keyboards. Certain keyboards with additional
functions may require custom firmware to operate. Keyboards with an integral
USB Hub (Mac
®
keyboards, for example) are also supported.
Mouse
Compatible with most 2-button, 3-button, and scroll mice.
Other฀USB฀HID฀devices
The proprietary USB emulation also supports certain other USB HID devices, such
as specific touchscreens, graphics tablets, bar-code scanners, or special keyboards.
Support cannot be guaranteed, however, for every USB HID device.
NOTE: Only two USB HID devices are supported concurrently, such as keyboard
and mouse or keyboard and touchscreen. A hub is allowed, but it does not
increase the number of HID devices allowed.
To support other USB “non-HID” devices, such as scanners, Web cams or memory
devices, choose our devices with transparent USB support.
1.1.3฀RJ-45฀(Network)
CATx device communication requires a 1000BASE-T connection. Pin the cable
according to EIA/TIA-568-B (1000BASE-T) standard with RJ-45 connectors at both
ends. All four wire pairs are used in both directions. The cabling is suitable for
full-duplex operation. For the cable connection to a source (computer, CPU), use a
cross-pinned network cable.