Black Box ServSwitch DKM FX - Control Options

Page 60
724-746-5500 | blackbox.com
Chapter฀4:฀Configuration
You can change the hotkey sequence to enter Command Mode. The following
table lists the hotkey codes for the available key sequences:
Table 4-2. Command mode components.
Hotkey฀codeHotkey
1 <Left-Ctrl> + <Left-Shift> + <i>
2 2x <Scroll>
3 2x <Left-Shift>
4 2x <Left-Ctrl>
5 2x <Left-Alt>
6 2x <Right-Shift>
7 2x <Right-Ctrl>
8 2x <Right-Alt>
NOTE: In a combined KVM matrix/U-Switch configuration, choose different
hotkeys for the KVM matrix and the U-Switch.
Set฀freely฀selectable฀“Hotkey”฀(exemplary)
To set a freely selectable Hotkey (for example, 2x <space>), use the following
keyboard sequence:
<current “Hotkey”>, <c>, <0>, <Space>, <Enter>
Reset฀“Hotkey”฀
To set a Hotkey back to the default settings of the extender, press the key
combination <Right-Shift> + <Del> within 5 seconds after switching on the CON
unit or plugging in a keyboard.
4.2 Control Options
The ServSwitch DKM FX contains an internal CPU that enables you to control all
functions from any console without the need for an external CPU or media
control.
You can access the ServSwitch DKM FX for configuration and operation in three
ways:
•฀via฀OSD
•฀via฀Java฀Tool
•฀via฀serial฀interface