Black Box ServSwitch DKM FX - Reset; Power down

Page 160
724-746-5500 | blackbox.com
Chapter 5: Operation
5.7.2 Reset
Use the OSD to reset the extender:
Figure 5-12. OSD icon.
CAUTION: If you do a factory reset, all current settings and all configurations
stored in the matrix will be lost. This also applies to the network
parameters (reset to DHCP) and the admin password.
NOTE: If a firmware update has been done since the delivery, the matrix will be
set to the state defined there.
OSD
1. Select “Configuration > Reset Matrix” in the main menu.
2. To confirm the selection, press the “Yes” button.
The ServSwitch DKM FX will be reset to the factory settings.
5.7.3฀Power฀Down
Slide the on and off switch at the main sockets of the power supply units to start
or switch off the matrix.