SERVSELECT IP™ INSTALLER/USER GUIDE
16
Figure 3-2. Basic ServSelect IP Configuration
CAUTION:
To reduce the risk of electric shock or damage to your equipment-
- Do not disable the power cord grounding plug. The grounding plug is an important safety feature.
- Plug the power cord into a grounded (earthed) outlet that is easily accessible at all times.
- Disconnect the power from the unit by unplugging the power cord from either the electrical
outlet or the unit.
To install the ServSelect IP hardware:
1. Connect a terminal or PC running terminal emulation software (such as
HyperTerminal™) to the confi guration port on the back panel of the appliance
using an RS232 DB9 null modem cable. The terminal should be set to
9600 bps, 8 data bits, 1 stop bit, no parity and no fl ow control.
Digital User
one user for the KV120 or
two users for the KV121
Network
Configuration Port
for updating firmware
ServSelect IP Appliance
ARI
Port
Power Cord
Local Analog
User
SAM Adaptor
PS/2, USB, Sun and
serial adaptors are
available
Servers 2-16
Server 1
To Next Page
Loading...
