CHAPTER 3: INSTALLATION
17
2. Plug the supplied power cord into the back of the appliance and then into an
appropriate power source.
3. When you turn on the power, the Power indicator on the front of the unit will
blink for 30 seconds while performing a self-test. Approximately 10 seconds after
it stops blinking, press the
Enter key to access the main menu.
To confi gure the ServSelect IP hardware:
1. You will see the Terminal menu with seven options. Select option 1, Network
Confi guration.
Figure 3-3. Terminal Menu
2. Select option 1 from the Network Confi guration menu to set your network
speed. When possible, you should set your connection manually without
relying on the auto negotiate feature. Once you enter your selection, you will be
returned to the Network Confi guration menu.
3. Select option 2 and specify if you are using a static or BootP IP address. Use a
static IP address for ease of confi guration. If you are using a BootP address,
please confi gure your BootP server to provide an IP address to the appliance, skip
step 4 and continue to the next procedure.
4. Select options 3-5 from the Terminal menu, in turn, to fi nish confi guring your
appliance for IP address, netmask and default gateway. Once this is completed,
type a
Ø to return to the main menu.
Adjusting mouse settings on target machines
NOTE:
We highly recommend that all Windows systems attached to the ServSelect IP appliance use the
default Windows PS/2 mouse driver.
To Next Page
Loading...
