SERVSELECT IP™ INSTALLER/USER GUIDE
18
Before a PC running Windows NT, 2000 or XP that is connected to the ServSelect
IP appliance may be used for remote user control, an adjustment to the target
mouse’s Motion tab must be made. Use the default Microsoft
®
Windows PS/2 mouse
driver for all Microsoft Windows systems attached to the appliance.
For Microsoft Windows NT (using default drivers):
1. From the Desktop, select Start - Settings - Control Panel - Mouse. The Mouse
Properties dialog box will appear.
2. Click on the Motion tab.
3. Set the Pointer speed to Slow. This will also need to be done for any NT user
account that will be accessing the NT system through the ServSelect
IP appliance.
4. Set Acceleration to None for mouse sync.
5. Click OK.
6. Click Mouse Align in the ServSelect IP software remote session window(s) to
resynchronize the mouse.
For Windows 2000 (using default drivers):
1. From the Desktop, select Start - Settings - Control Panel - Mouse. The Mouse
Properties dialog box will appear.
2. Click on the Motion tab.
3. Set Speed to the default of 50% (the sixth tick mark from the left).
4. Set Acceleration to None for mouse sync.
5. Click OK.
6. Click Mouse Align in the ServSelect IP software remote session window(s) to
resynchronize the mouse.
For Windows XP or Windows Server 2003 (using
default drivers):
1. From the Desktop, select Start - Control Panel - Mouse. The Mouse Properties
dialog box will appear.
2. Click on the Pointer Options tab.
3. Set Speed to the default of 50% (the sixth tick mark from the left).
4. Uncheck the Enhance pointer precision checkbox.
5. Click OK.
To Next Page
Loading...
