CHAPTER 3: INSTALLATION
21
Figure 3-4. ServSelect IP Configuration with a Legacy KVM Switch
To add a KV158A ServSwitch Multi Z8 switch:
1. Mount the Z8 into your rack cabinet. Locate a length of CAT 5 cabling to
connect your appliance to the SAM for your Z8.
2. Attach one end of the CAT 5 cabling to the RJ45 connector on the SAM.
3. Connect the other end of the CAT 5 cable to a port on the back of your
ServSelect IP.
4. Attach the keyboard, monitor and mouse connectors of the SAM to a user port
on your Z8.
5. Connect the servers to your Z8 according to the instructions in the Z8 manual.
6. Power cycle the Z8 to enable the cascade code.
7. Repeat steps 2-6 for all Z8s or you want to attach to your system.
ServSelect IP Appliance
Server Access
Modules (SAMs)
(KV123A, KV125A - KV127A)
PS/2, USB, Sun and serial
module versions are
available
KV158A
ServSwitch
Server 1
Local
Analog
User
Server 1
KV2016A
ServSelect II
To Next Page
Loading...
