SERVSELECT IP™ INSTALLER/USER GUIDE
28
Assigning server or serial device names
Use the Names dialog box to identify individual servers or serial devices by name
rather than by port number. The Names list is always sorted by port order. Names
are stored in the SAM, so even if you move the module/server/serial device to
another ARI port, the name and configuration will be recognized by the appliance.
NOTE:
If a server or serial device is turned off, its respective SAM will not appear in the Names list.
To access the Names dialog box:
1. Press
Print Screen. The Main dialog box will appear.
2. Click Setup - Names. The Names dialog box appears.
Figure 4-3. Names Dialog Box
NOTE:
If new SAMs are discovered by the ServSelect IP software, the on-screen list will be
automatically updated. The mouse cursor will change into an hourglass during the update. No
mouse or keyboard input will be accepted until the list update is complete.
To assign names to servers or serial devices:
1. In the Names dialog box, select a server or serial device name or port number
and click Modify. The Name Modify dialog box appears.
Figure 4-4. Name Modify Dialog Box
To Next Page
Loading...
