CHAPTER 4: ANALOG PORT OPERATION
29
2. Type a name in the New Name box. Names of servers or serial devices may be up
to 15 characters long. Legal characters include: A-Z, a-z, Ø-9, space and hyphen.
3. Click OK to transfer the new name to the Names dialog box. Your selection is
not saved until you click OK in the Names dialog box.
4. Repeat steps 1-3 for each server or serial device in the system.
5. Click OK in the Names dialog box to save your changes.
-or-
Click X or press
Escape to exit the dialog box without saving changes.
NOTE:
If a SAM has not been assigned a name, a combination of the EID and port name is used as
the default name.
Assigning device types
The appliance automatically discovers ServSwitch Multi Z8s and ServSelect IIs that
are attached to it and will automatically assign the number of ports (eight) to that
switch. You will see an Sw-8 appear in the Type category. When you select that
switch from the list, the Modify button appears, but do not click it. At this time, the
KV158A 2 x 8 ServSwitch Multi Z8 and KV2016A 2 x 16 ServSelect II are the only
available cascade switches; do not attempt to select or add other switch types, or
specify a different number of ports.
To access the Devices dialog box:
1. Press
Print Screen. The Main dialog box will appear.
2. Click Setup - Devices. The Devices dialog box appears.
NOTE:
The Modify button will only be available if a confi gurable switch is selected.
Figure 4-5. Devices Dialog Box
To Next Page
Loading...
