SERVSELECT IP™ INSTALLER/USER GUIDE
30
When the ServSelect IP appliance discovers a ServSwitch Multi Z8 or ServSelect II,
you will notice the port numbering change to accommodate each server under that
switch. For example, if the switch is connected to ARI port 6, the switch port would
be listed as 06 and each server under it would be numbered sequentially 06-01, 06-
02 and so on.
To assign a device type:
1. In the Devices dialog box, select the desired port number.
2. Click Modify. The Device Modify dialog box appears.
Figure 4-6. Device Modify Dialog Box
3. Choose the number of ports supported by your switch and click OK.
4. Repeat steps 1–3 for each port requiring a device type to be assigned.
5. Click OK in the Devices dialog box to save settings.
NOTE:
Changes made in the Device Modify dialog box are not saved until you click
OK
in the Devices
dialog box.
Changing the display behavior
Use the Menu dialog box to change the display order of servers and set a Screen
Delay Time for the OSD. The display order setting alters how servers will display in
several screens including the Main, Devices and Broadcast dialog boxes.
To access the Menu dialog box:
1. Press
Print Screen to launch the OSD. The Main dialog box appears.
2. Click Setup - Menu in the Main dialog box. The Menu dialog box appears.
To Next Page
Loading...
