89
ENGLISH DEUTSCHFRANÇAISITALIANO
NEDERLANDS
Tuner mode
SVENSKA
nouncements, the tuner exclusively ad-
justs traffi c information stations.
Note:
These settings are available only for FM.
An exact description of these settings
can be found in the following sections of
this chapter.
Tuning into stations manually
Notes:
Tuning into stations manually is pos-
sible only if the convenient RDS func-
tion is deactivated.
If the RDS function is activated, you
can scroll in the broadcasting net-
works in whose reception area you
are located.
Press the # button of the alphanumer-
ic keys
9.
"SEEK" and the current frequency or the
station name appear on the display.
Press the rocker switch
or : to
change the frequency in increments of
100 kHz.
Note:
You can also activate the "SEEK" func-
tion by using the
rocker switch : to
open the "Tune" menu and pressing the
OK button
2.
Selecting stored stations
Select the desired waveband or mem-
ory bank.
Press one of the station buttons
0 - 9
9.
•
•
쏅
쏅
쏅
쏅
Or in the List menu:
Press the rocker switch
or : to
select a frequency or station from the
list.
Press the OK button
2.
The stored station is called up, provided
that it can be received at the current vehi-
cle position.
The frequency of the station or the station
name appears on the display.
Storing stations
There are 2 ways of storing a station:
Storing stations manually
Searching and storing stations automat-
ically (Travelstore)
Storing stations manually
After tuning into a station, it can be stored
as follows:
Press one of the station buttons 0 - 9
9
for approx. 2 seconds to which you want
to assign the station.
Or in the List menu:
Press the rocker switch
or : to
select a memory location in the list.
Press and hold down the OK button
2
for approx. 2 seconds.
The list displays the frequency or the name
of the station at the selected memory loca-
tion. The station was stored.
쏅
쏅
•
•
쏅
쏅
쏅
02BA_HamburgMP68_gb.indd 8902BA_HamburgMP68_gb.indd 89 03.03.2008 8:58:54 Uhr03.03.2008 8:58:54 Uhr
To Next Page
Loading...
