Blaupunkt Kingston MP47 - Preamplifi er Output (Preamp-Out;Sub-Out); Adjusting Sub-Out Level and Sub-Out Cut-Off Frequency

71
ENGLISH
Preamplifi er output
(Preamp-Out/Sub-Out)
You can use the preamplifi er outputs
(Preamp-Out) of the car sound system to
connect external amplifi ers. In addition,
you can connect an amplifi er for operating
a subwoofer to the integrated dynamic low-
pass fi lter of the device (level and cut-off
frequency can be adjusted).
For this purpose, the amplifi ers must be
connected as described in the installation
instructions.
Adjusting Sub-Out level and Sub-
Out cut-off frequency
The sub-out level can be adjusted in 8 incre-
ments (0 to +7). You can also select 1 of 4
cut-off frequencies: 0 Hz, 80 Hz, 120 Hz
and 160 Hz.
Press the AUDIO button 7.
"BASS" appears on the display.
Press the
or button < repeat-
edly until "ENHANCED" appears on the
display.
Press the MENU/OK button ;.
"E-BASS" appears on the display.
Press the
or button < repeat-
edly until "SUB-OUT" appears on the
display.
Press the
button 9 to open the Sub-
Out menu.
"GAIN" and the current setting appear on
the display.
쏅
쏅
쏅
쏅
쏅
Press the
or button < to switch
between the setting options "GAIN"
(level) and "FREQ" (cut-off frequency).
Set the level and cut-off frequency with
the
or button 9.
When you have fi nished making your chang-
es,
press the ESC/DIS button 5.
쏅
쏅
쏅
Preamplifi er output
02_KingstonMP47_eng.indd 7102_KingstonMP47_eng.indd 71 23.01.2007 16:41:23 Uhr23.01.2007 16:41:23 Uhr