75
ENGLISH
External audio sources
External audio sources, such as portable
CD players, MiniDisc players or MP3 play-
ers, can be connected to the device in two
ways:
Via the rear AUX input (if no CD changer
is connected to the device).
Notes:
An adapter cable is needed to con-
nect an external audio source via the
rear AUX input. You can obtain this ca-
ble (Blaupunkt no.: 7 607 897 093)
from your Blaupunkt dealer.
With the SOURCE button =, you can
select the rear AUX input. The display
then shows "CDC/AUX".
2. Via the front AUX-IN socket.
Note:
As soon as an audio source is connect-
ed to the front AUX-IN socket, it can be
selected with the SOURCE button =.
The display then shows "AUX".
1.
•
•
Restoring factory settings
(NORMSET)
You can restore the original factory settings
of the device.
Press the MENU/OK button ;.
Press the
or button < repeat-
edly until "NORMSET" appears on the
display.
Press the MENU/OK button ; repeat-
edly until "NORM ON" appears on the
display.
The device switches off and immediately
on again. All settings are returned to the
factory settings.
Note:
If you do not press and hold the MENU/
OK button ; long enough, "NORM
OFF" appears on the display. In this
case, your individual settings remain
intact and the device remains switched
on. You can exit the menu with the
ESC/DIS button 5.
쏅
쏅
쏅
External audio sources Factory settings
02_KingstonMP47_eng.indd 7502_KingstonMP47_eng.indd 75 23.01.2007 16:41:24 Uhr23.01.2007 16:41:24 Uhr
To Next Page
Loading...
