74
Mixing a colour for the display
illumination
To customise the display illumination to suit
your tastes you can either mix a colour your-
self using the three primary colours red,
green and blue (RGB) or from the colours
red and green (RG).
Press the MENU/OK button ;.
Press the
or button < repeat-
edly until "DISP COL" appears on the
display.
Press the
button 9 to open the RGB
menu or the
button 9 to open the
RG menu.
The display shows "4096 COL" for the RGB
menu or "256 COL" for the RG menu.
Press the
button 9 to open the
menu for mixing your own colour.
Either "R", "G", and "B" or "R" and "G" are
displayed with the current values. The set-
ting for "R" is activated. You can adjust a
value from 0 to 16 each for every available
colour component.
Press the
or button < to adjust
the value of a colour component.
Press the
or button 9 to switch
between the colour components.
When you have fi nished making your chang-
es,
press the MENU/OK button ;.
Press the ESC/DIS button 5 to exit
the menu.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Selecting a display illumination during a
colour scan
Press the MENU/OK button ;.
Press the
or button < repeat-
edly until "COL SCAN" appears on the
display.
Press the MENU/OK button ; to start
the colour seek.
The device starts changing the display illu-
mination colour.
To select the currently set colour,
press the MENU/OK button ;.
With the MENU/OK button ;, you can
start the colour seek again and select a dif-
ferent colour.
If you found and selected the desired col-
our,
press the ESC/DIS button 5.
쏅
쏅
쏅
쏅
쏅
Display
02_KingstonMP47_eng.indd 7402_KingstonMP47_eng.indd 74 23.01.2007 16:41:24 Uhr23.01.2007 16:41:24 Uhr
To Next Page
Loading...
