ENGLISH
Operating the tuner
25
Storing stations
After locating a station, you can
store it as follows:
Select the desired memory
bank (see page 23).
Press the softkey for approx.
two seconds to which you
want to assign the station.
The station is stored. A signal
tone confi rms that the station
has been stored.
The display briefl y shows the
assignment of the six memory
locations of the current memo-
ry bank. The current station is
highlighted.
Note:
To automatically search for
FM stations and store them in
the FMT memory bank (Travel-
store), see page 28.
Listening to stored stations
Select the desired memory
bank (see page 23).
Briefl y press the softkey which
is assigned to the station you
want to set up.
The display may briefl y show
the assignment of the six mem-
ory locations of the current
memory bank. The current sta-
tion is highlighted. The desired
station is played back provided
➔
➔
➔
➔
that it can be received at the
current vehicle position.
Press the OK button
A or
the ESC button
@ or wait for
16 seconds.
The tuner display shows the
frequency and possibly the
name of this station, provided
that the station broadcasts this
RDS information.
In addition, the memory loca-
tion of the radio station
D is
highlighted.
Scanning all receivable
stations (Scan)
Select the waveband (FM, AM)
whose receivable stations you
want to scan (see page 27).
Press and hold the OK button
A for approx. two seconds.
The tuner searches for stations
in the current waveband. The
display shows "SCAN" every
two seconds.
As soon as the tuner has locat-
ed a station, it is played and
the station name or the station
frequency appears on the dis-
play. The scan time can be set
as described on page 54 and
55 under "Scan Time".
After the frequency band has
been completely searched
once, the search stops and the
➔
➔
➔
01_BA_Memphis_US_gb.indd Tuner2501_BA_Memphis_US_gb.indd Tuner25 05.09.2007 9:58:09 Uhr05.09.2007 9:58:09 Uhr
To Next Page
Loading...
Need help?
General
Weight and Dimensions
