Blaupunkt MEMPHIS MP66 - Changing Volume Presettings (Volume Settings); The Telephone (Phone Volume); Changing the Volume Presetting of the Signal Tone (Beep Volume); Changing the Volume Presetting of the Telephone (Phone Volume)

ENGLISH
Changing basic settings in the settings menu
49
Changing volume presettings ( Volume Settings)
In the "Volume Settings" menu, select the volume presettings for traf-
fi c announcements, the telephone, the signal tones, etc.
Press the MENU button ?. The settings menu appears.
Press the softkey
9 (next to "Volume Settings").
The "Volume Settings" menu appears. The volume presettings are
displayed as two-digit numbers. One of the two menu items "On Vol-
ume" or "Last Volume" is highlighted.
➔
➔
Changing the volume presetting
of the telephone ( Phone Volume)
If the device puts a phone call
through, it always starts at the pre-
set volume.
Press the softkey 8 (next to
"Phone Volume").
The volume presetting for
phone calls appears.
Adjust the desired volume
using the volume control
5 or the rocker switch 3
(increments 1 to 50).
➔
➔
During the phone call, you can
always change the volume by
means of the volume control
5.
Changing the volume presetting
of the signal tone ( Beep Volume)
If a signal tone sounds, you al-
ways hear it at the preset volume.
Press the softkey
9 (next to
"Beep Volume").
The volume presetting for the
signal tone appears.
➔
01_BA_Memphis_US_gb.indd Menü4901_BA_Memphis_US_gb.indd Menü49 05.09.2007 9:58:13 Uhr05.09.2007 9:58:13 Uhr