Error table
56
You can adjust scan times in in-
crements of 5 seconds form 5 to
30 seconds.
Displaying the serial number
( Serial Number)
Every device has a separate serial
number. To display this number:
Press the softkey
: (next to
"Serial Number").
The serial number is displayed.
➔
Error table
If the device does not function properly, switch the device off and on
again.
If problems still persist, you can easily correct the following problems.
Problem Possible cause Possible remedy
The menus do not appear
as shown in these instruc-
tions.
The tuner cannot be adjust-
ed to the frequencies listed
in the technical data
.
The device is not set to
your region.
Set the device to your region
as described on page 26.
The display shows informa-
tion about the device.
The demo mode is acti-
vated.
Briefl y press the MENU-
button
?, then press the
MENU button
? again and
hold it pressed for four sec-
onds.
The device is always silent,
even though it is correctly
connected.
The internal amplifi er is
switched off.
Switch on the internal
amplifi er as described
on page 55.
If problems still persist, please contact an authorised workshop or the
Blaupunkt customer service (see the last page).
01_BA_Memphis_US_gb.indd Fehler5601_BA_Memphis_US_gb.indd Fehler56 05.09.2007 9:58:14 Uhr05.09.2007 9:58:14 Uhr