19
If the TravelPilot TA function is active, traffic announcements will be broadcast
at the minimum volume selected in the Set-up Volume.
If the TA function is activated for the other sources, (CD player and CD changer
as well as navigation), playback will be interrupted for an incoming traffic an-
nouncement and the message will be broadcast. When the traffic announce-
ment is completed, playback will resume.
If the TA function is active and you select a radio station manually which does
not support traffic information, you will hear a warning beep. In this case, the
system will start an automatic search for a TP station after the warning beep has
sounded.
Activating/deactivating the TA function for radio operation
Use the DSC menu for the corresponding source to activate or deactivate the
TA function. A TA symbol in the status line indicates that the TA function is
active.
Press DSC ; to switch to the DSC menu for the tuner and
Press the softkey marked
TA
repeatedly until the desired option,
ON
or
OFF
, appears.
ON
is the default setting.
Note: You can also use the hotkey to switch the TA function on and
off. For information on how to program the hotkey, refer to the sec-
tion on “Programming the hotkey” in the chapter on Set-up/Default
settings.
Interrupting traffic announcements
To interrupt traffic announcements, press DSC ;, AUD :, TU @ and CD.C
? or select a different radio station. If you have programmed the Hotkey ac-
cordingly, you can also interrupt traffic announcements by pressing this key.
Radio operation
Tuner DSC menu
To Next Page
Loading...
