81
Calibrating the system after a tyre change
After a tyre change it might be necessary to calibrate the TravelPilot again.
Select
CALIBRATION
from the Set-up menu Install.
Mark and confirm the menu item
TYRE CHANGE
.
Follow the instructions given to you by the system.
Calibrating the system manually
You can also calibrate the system manually. To do so, you have to drive a dis-
tance of at least 100 meters at a maximum speed of 30 km/h. Please note that
the distance must be measured out exactly.
Select
CALIBRATION
from the Set-up menu Install.
Mark and confirm the menu item
MANUALLY
.
Now you will be required to enter the distance you intend to drive.
Select the first digit indicating the distance and
Press OK 8.
Enter the remaining digits in the same way.
Press the symbol and OK 8 to confirm your entry or press OK 8 for
a longer time.
You will be instructed to drive this distance.
Use << >> on the rocker switch 7 to select
START
.
Follow the instructions given to you by the system.
Set-up/Basic settings
To Next Page
Loading...
