80
Follow the instructions given to you by the system and
Press OK 8.
You can cancel the process at any time. If you want to end the installation,
Use << >> on the rocker switch 7 to select
CANCEL
and
Press OK 8.
The previous menu item in the installation will appear.
Following the system test the system will perform the actual calibration. To do
so, you must drive a distance of 8 to 15 km with good GPS reception.
First select the option you require,
NEW INSTALL
or
TYRE CHANGE.
Press OK 8.
Before the process begins, you will be prompted to confirm the deletion of any
old calibration information.
Note: If you select
NEW INSTALL
, route guidance is not possible
during the first 25% of the calibration process.
The distance you will be required to drive depends on a number of
different factors such as the quality of GPS reception and the route.
The number of kilometres given is only a guideline. The distance
can be much shorter or much longer if conditions are unfavourable.
Set-up/Basic settings
Set-up menu Install
To Next Page
Loading...
