bluelab pH Controller Wi-Fi - 4.2 Connect to a different Wi-Fi Network

4.2 Connect to a different Wi-Fi Network
To reprovision:
1.
Use the menu
item
‘Wi
-
Fi’
.
2. Press ‘’ to select ‘Provisioning’.
3. The security code is displayed
indicating that the device is ready to
accept new Wi-Fi settings.
4. Use the Edenic App on your mobile
to complete the setup for a new
network.
4.3 Enable / Disable Wi-Fi
By default, Wi
-
Fi is enabled. If you want to disable Wi
-
Fi follow these instructions:
1.
Use the menu item ‘Wi
-
Fi’.
2. If turned on, the status is shown
above the menu.
a. Conn – Wi-Fi is connected
b. Err1 – Wi-Fi not connected
c. Err2 – No internet available
d. Err3 – Edenic service not
reachable
e. Err4 – Time sync, please
wait.
3. Select ‘Data’ and ‘’ to enter Data
menu.
4. Select Off to disable Wi-Fi.
On to enable.