Detailed assembly instructions
60
Wheels and axles
WARNING: Your bike is delivered pre-assembled with inner tubes for transportation and display.
Always setup the wheels following the recommendations and instructions of the wheel and the tire
manufacturers:
• Some wheels must only be assembled tubeless
• Some wheels must only be installed with specific tires for a tubeless setup (hookless rims)
• Even if the wheels are tubeless, some tires assembled on some bike models may not be tubeless
Please read carefully the tires and the wheels instructions.
WARNING: Make sure tubeless compatibility is guaranteed between your wheels and your tires:
• Minimum and maximum tire size
• Minimum and maximum tire pressure
• Tire bead design (hooked or hookless)
• Rim design (hooked or hookless)
• Grease the thread and the head of the thru-axles.
Grease
6 10 Nm
• Thru-axles must be torqued to 10 Nm using a hex 6mm.
• Once installed, you can plug the rubber aero caps into the fork and the rear dropout.
To Next Page
Loading...
