Detailed assembly instructions
62
Third party fenders
By design, the Roadmachine 01 and Roadmachine frames are compatible with quick mount clip-on
fenders or full length fenders with stays.
Roadmachine 01 is only compatible with quick mount clip-on fenders.
Engineered as the lightest frame, the Roadmachine 01 does not feature threads and brackets to
install classic fenders using stays bolted on the frame and fork.
Roadmachine is compatible with both full fenders with stays and quick mount clip-on fenders.
The engineering of the Roadmachine frame and fork integrate fender attachements and stays at-
tachements.
Examples of quick mount clip-on fenders
• SKS Raceblade Pro
• TOPEAK Tetrafender R1 / R2
• TOPEAK Defender RC1 / RC11
Examples of full fenders with stays
• SKS Bluemels Cable Line 28” 45 (full length)
• SKS Edge AL 46 (full length)
WARNING: You must carefully install your fenders so they don’t damage your frame or its com-
ponents. Road vibrations could cause the fenders to vibrate and rattle causing paint damage and
frame structural damage or components damage. Damage may result in component faillure and
result in loss of control and falling.
WARNING: Protect the frame by applying protective tape. This will avoid fenders to scratch or
damaging the frame’s paint or even damaging the frame’s structure.
WARNING: Lots of fender options are available on the market. Even if their design is optimized
for road bikes, you may have to modify their shape and use different bolts, washer, spacers and
nuts.
WARNING: Tire clearance is affected by the installation of fenders. Always respect a clearance
of 4mm all around the tire to guaranty your safety.
Depending on your fender choice and installation, you may have to change your tire size to get the
appropriate tire-to-fender clearance.
WARNING: Always follow the fender manufacturer’s recommendation for installation.
To Next Page
Loading...
