The JAYCOMMAND system can be equipped
with a SmartPressure Tire Monitoring
System. If available on your RV, the Tire
Pressure Monitoring System allows the
pairing and monitoring of your tire sensors,
with the flexibility of adjusting your
temperature and pressure warning limits.
The SmartPressure sensor will transmit
every 10 minutes when your RV is stationary
and every minute when in motion.
TIRE MONITORING SYSTEM (TPMS)
TPMS NOTIFICATIONS
If the pressure or temperature is out of
limits, a warning notification will appear
on your smartphone.
PAIRING SMARTPRESSURE SENSORS
1. Go to the Status Screen where the
Tire Pressure is displayed.
2. Press the “PAIR” button at the desired
location to install the pressure sensor.
3. Install the pressure SmartPressure sensor
on tire at the same selected location in step 2.
4. Once pairing is successful, the pressure
and temperature levels will be displayed
FIGURE 25:
SmartPressure Sensor
If the pairing is unsuccessful an error
message, will be displayed -
Pairing Failed: Cannot Detect Sensor
Press “TRY AGAIN” to restart the process.
The pressure will display “-“, if the valid
pressure is not received by the system.
• Wait for the sensor to send the information
• Check if the sensor is installed on the tire
• Check the sensor battery status.
FIGURE 26: Low Tire
Pressure Warning
FIGURE 27:
SmartPressure Status
22
To Next Page
Loading...
Need help?
General
