WARNING THRESHOLDS
To adjust your warning thresholds for both temperature and pressure sensors,
press on the “Settings” button in the top right corner of the Status screen.
The user will be able to set the minimum and maximum limits for pressure and
temperature. If these limits are exceeded, a warning sign will appear for the
corresponding pressure/ temperature sensor.
SMARTTEMP SETTINGS
Press the “SETTINGS” button at the top
right corner of the screen to set the desired
minimum and maximum temperature limits
for the paired temperature sensor. If these
limits are exceeded, a warning will appear.
UNPAIR SMARTTEMP SENSOR
Press the “Unpair” button in the temperature
tile to remove the sensor from the system.
Press “Done” to confirm unpairing.
FIGURE 32: SmartTemp Screens
Refer to BATTERY REPLACEMENT on page
31 to check the battery status of the sensor
and for instructions on battery replacement.
27
To Next Page
Loading...
