BMPRO JAYCOMMAND Manual

FIGURE 38: Replacing SmartPressure Battery
FIGURE 39: Replacing SmartSense Battery
Lift the board with
electronics carefully,
replace CR2032 battery.
Place lid back into base
and press down fully to
reengage all 4 snap fits.
Using a small screwdriver,
lift the lid which is held by
the snap fit.
FIGURE 40: Replacing SmartTemp Battery
Align the groove in
the PCB with two
pieces of plastic
Lift the board
with electronics
carefully, Replace
CR2477 battery.
Align the button on the
PCB with the button on the
base of sensor. Press the
base down until locked.
Using a small
screwdriver, lift
the lid from the
recess side.
To check if any SmartConnect sensor batteries need to be changed, please select:
1. Settings
2. Battery Level
3. SmartConnect sensor (SmartPressure, SmartSense, SmartTemp)
4. Under selected sensor, the battery status will either display
"Battery OK" or "Battery Low."
If “Battery Low” appears, replace the battery using the following instructions.
BATTERY REPLACEMENT
31

BMPRO JAYCOMMAND Specifications

General

Brand	BMPRO
Model	JAYCOMMAND
Category	Controller
Language	English