WARNING
Only install the SmartSense as described below. No field assembly is required. The
sync process to the JAYCOMMAND APP on your smart JAYCOMMAND DISPLAY, as
described below, should occur in an area clearly out of any explosive atmosphere.
Once SmartSense is synced to JAYCOMMAND, the device is “in service” and
operating normally. Device will then operate continually until battery is otherwise
removed or changed. There is no “Power Off” mode from that point forward. Once in
service, the device may then be moved, repositioned, or removed from the tank as
needed, without any special instruction or changes to the device.
SmartSense is not intended for repair or maintenance, other than changing the
battery per subsequent sections of this manual. Any modification of the SmartSense
may result in an unsafe condition.
SmartSense Should be removed from tank and opened for battery change, clearly
away from any explosive atmosphere.
Do not use SmartSense for any other application, other environment, or in any other
manner than as stated in this manual. Any misuse may result in an unsafe condition.
The operational temperature for the SmartSense is ranging from 13ºF to 104ºF.
To Next Page
Loading...
