Bodystat 1500 - Operational Features Overview

12
OPERATIONAL FEATURES
The BODYSTAT
®
1500 hand-held unit has been specifically designed to
facilitate ease of use, speed of input and subsequent access to subject data.
The following operational features are provided:
SELECTION
WHAT TO DO
BUTTON IMAGE
Turning the device
ON/OFF
Press and hold briefly
the On/Off Button
Entering Subject Data
and performing a
measurement
Press the New Test
button after switching
the device on
Installation/Options
Mode
Includes options for:
- Language Options
- Display Options
- Imperial/Metric
Press the Options
button after switching
the device on.
Serial Number/Year of
Manufacture
Press the Information
button after switching
the device on.
Recall Subject Data
Press the Recall Data
button after switching
the device on.
Subject data may be entered, displayed and recalled in imperial or metric
measurements and may be altered at any time.
The BODYSTAT
®
1500 unit is initially programmed to display ALL measurement
data except the Lean % which is not shown as a factory default option. The
operator, however, can choose to display specific information only (refer
INSTALLATION MODE, page 14).
The most recent 100 tests are always automatically stored in the memory of the
BODYSTAT
®
1500 unit and subject data may be recalled at any time. Data
stored in memory is not lost after the unit is switched off (refer RECALL
SUBJECT DATA, page 29).
If the unit has been switched on and no data has been entered for 60 seconds,
an alarm signal sounds to warn the operator that the unit is still on and that
battery power is being utilized.