EasyManuals Logo

Boge SF 100-2 User Manual

Boge SF 100-2
72 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
Aufstellung.pm6.5 - USA
Page 3.5
Installation
BOGE Operating instructions for S 40-2...S 341 / SF 40-2...SF 220 series screw compressors
General
BOGE screw compressor units are supplied ready for connection. Only the
work described in the following paragraphs needs to be carried out during
the installation.
CAUTION!
Only have the installation work carried out by appropriately trained persons
or specialists.
Prior to delivery, each compressor is subjected to a trail run at the factory.
It is carefully tested and set. However, possible transport damage cannot be
excluded.
Please inspect the compressor immediately after delivery and direct dam-
age claims to the last haulier even when the packing is not damaged!
To safeguard claims against the haulier we recommend leaving the
machine, devices and packing material in the same condition as they
were in when the damage was detected.
Prior to commissioning, check the compressor for external damage.
Observe the compressor very closely during commissioning and the
following trial run.
If malfunctions occur, switch off the compressor immediately and inform
the BOGE-Service.
The delivery scope depends on your order.
Prior to commissioning, please check whether all required parts have been
provided. Please check the order confirmation for any possible accessory
equipment.
The delivery scope includes the following component parts:
Operating instructions
Keys
Electric circuit diagram (in the compartment of the switch cabinet)
List of electrical equipment (in the compartment of the switch cabinet)
Remove the packing material on and in the compressor.
Install compressor and align horizontally.
The compressor must stand firmly on the ground on all feet.
Connect the compressor to the compressed air network or a compressed
air receiver.
For this, use a BOGE high pressure hose.
NOTICE!
Do not install a check valve in the pressure line.
The compressor is already equipped with a check valve.
Checking the delivery
scope
Installing
the compressor
Connecting the
compressor to the
compressed air network
3.3 Installation

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Boge SF 100-2 and is the answer not in the manual?

Boge SF 100-2 Specifications

General IconGeneral
BrandBoge
ModelSF 100-2
CategoryCompressor
LanguageEnglish

Related product manuals