Bomag BPR 35/60 - Page 42

Wartung wöchentlich
BOMAG44 BPR 35/60
Fig. 45
l Check the rubber seal (Fig. 45), replace the
rubber seal if it is damaged.
l Clean out the air filter housing with a cloth.
Caution
!
Contaminants or dirt must not enter into the in-
take channel.
Fig. 46
l Separate the foam rubber and the paper ele-
ment of the air filter (Fig. 46).
l Check both elements carefully for signs of
damage, replace damaged elements.
Danger
!
Danger of injury!
Always wear protective clothes (goggles,
gloves) when working with compressed air.
Fig. 47
l Blow the paper element (3) (Fig. 47) carefully
out from inside to outside with dry, clean com-
pressed air (do not exceed 29bar). In case of
excessive contamination replace the paper el-
ement.
l Clean the foam insert (2) in warm soapy water,
rinse it and let it dry thoroughly.
l Soak the foam insert in clean engine oil and
press excessive oil out.
l Pull the foam rubber insert over the paper ele-
ment .
l Insert the air filter correctly and tighten the
wing nut.
Caution
!
If the air filter is not correctly inserted, dust
and foreign particles can enter into the air in-
take channel.
l Fasten the air filter cover with the wing nut.
Go to Discount-Equipment.com to order your parts