Bomag BPR 35/60 - Clean the Slurry Filter; Check the Oil Level in the Exciter Housing

Maintenance every 6 months
BOMAG 49BPR 35/60
6.13 Clean the slurry filter
Danger!
Fire hazard!
Gasoline is easily inflammable, do not spill.
When working on the fuel system do not use
open fire, do not smoke.
Danger
!
Health hazard!
Do not inhale any fuel fumes.
Fig. 53
l With the fuel tap closed unsrew the fuel sludge
filter (1) (Fig. 53) and wash out in fuel.
l Check the O-ring (2) for damage, replace if
necessary.
l Turn the fuel sludge filter in tightly and mind
the O-ring.
6.14 Check the oil level in the ex-
citer housing
Caution
!
Park the machine on level ground.
For quality and quantity of oil refer to the ”ta-
ble of fuels and lubricants”.
l Clean the area around breather and drain
plug.
Fig. 54
l Unscrew the bleeding screw (1) (Fig. 54).
l Unscrew the oil drain plug (2) and check the oil
level.
The oil level must reach the bottom edge of the
drain bore.
l If the oil level is too low top up oil immediately.
l Clean oil drain and bleeding screw and as-
semble both screws with sealing compound
(e.g. BOMAG part-no. 00970016).
690183
2
1
Go to Discount-Equipment.com to order your parts