Bomag BPR 70/70 D - As Required Maintenance Tasks

8.11 As required
8.1
1.1 Cleaning the machine
Protective equipment:
n
W
orking clothes
n
Safety shoes
n
Protective gloves
1.
Park the machine safely
Ä Chapter 6.5 „Parking the machine
in secured condition“ on page 60.
2. Allow the engine to cool down for at least
30 minutes.
3.
NOTICE!
Electric components can be damaged by
water entering into the system!
– Do not guide the water jet directly into the
openings of the crank handle, into the air
filter or onto electrical equipment.
Clean the machine from the outside and inside with a water
jet.
4. W
arm up the engine for a while to avoid corrosion.
8.11.2 Cleaning the cooling fins and the cooling air intake openings
How dirty the cooling fins and cooling air intake
openings are depends very much on the daily
operating conditions; clean daily if necessary
.
Protective equipment:
n
W
orking clothes
n
Protective gloves
n
Safety goggles
1.
Park the machine in secured condition
Ä Chapter 6.5
„Parking the machine in secured condition“ on page 60.
2. Allow the engine to cool down.
3. Remove dried dirt with a suitable brush from all cooling fins
and cooling air intake openings.
4.
CAUTION!
Danger of eye injuries caused by particles
flying around!
– Wear your personal protective equipment
(safety gloves, protective working
clothes, goggles).
Blow out the cooling fins and cooling air intake openings with
compressed air
.
Fig. 101: Cleaning the machine
(example)
Fig. 102
Maintenance – As required
BPR 70/70 D
95
Go to Discount-Equipment.com to order your parts