Bomag BPR 70/70 D - Checking the Oil Level in the Exciter Housing; Measures Prior to Extended Shut-Down Period

8.11.4 Checking the oil level in the exciter housing
NOTICE!
Components may get damaged!
– Use only oil of the permitted specification
Ä Chapter 8.4 „List of fuels and lubri-
cants“ on page 75.
– Do not use low-ash engine oils for the exciter
shaft housing.
Protective equipment:
n
W
orking clothes
n
Protective gloves
1. Park the machine on level ground.
2.
Park the machine in secured condition
Ä Chapter 6.5
„Parking the machine in secured condition“ on page 60.
3. Allow the machine to cool down.
4. Clean the area around the bleeding screw (1) and filling /
drain plug (2).
5. Unscrew the bleeding screw
.
6. Unscrew the filling / drain plug and check the oil level, top up
if necessary
.
ð
Nominal value: Bottom edge of filling / drain bore.
7. Clean bleeding screw and filling / drain plug and screw them
in with a low-strength sealing agent (
e.g. spare parts number:
009 700 16).
8.11.5 Measures prior to extended shut-down period
8.11.5.1 Measures before shutting down
If the machine is shut down for a longer period of time, e.g. winter
season, the following work must be carried out:
1. Clean the machine thoroughly
.
2. Clean the water separator
.
3. Fill the fuel tank with diesel fuel to prevent the formation of
condensation water in the tank.
4. Change engine oil and oil filter
.
5. Change the fuel filter
.
6. After shutting down store the machine under cover in a dry
and well ventilated room.
7. Protect the cooled down engine against dust and moisture.
2
1
B-692-0197
Fig. 106
Maintenance – As required
BPR 70/70 D
97
Go to Discount-Equipment.com to order your parts