1. Loosen screw (3) on the rocker arm.
2. Adjust the screw (2), until the feeler gauge (1) can be
inserted and pulled out with a barely noticeable resistance
after the hexagon nut (3) has been tightened.
1. Install the valve cover with a new seal and tighten the screws
evenly
.
2. After a short test run check the valve cover for leaks.
8.9.3
Changing engine oil and oil filter element
NOTICE!
Danger of engine damage!
– Change the oil only with the engine at oper-
ating temperature.
– Use only oil of the permitted specification
Ä
Chapter 8.3.1 „Engine oil“ on page 72.
– Filling quantity:
Ä
Chapter 8.4 „List of fuels and
lubricants“ on page 75
Adjusting the valve clearance
Fig. 82
Final work
Fig. 83
Maintenance – Annually / every 250 operating hours
BPR 70/70 D
86
Go to Discount-Equipment.com to order your parts
To Next Page
Loading...
