Arming all areas
4 Enter your code, press [0] [0] and [#].
P The system beeps twice, the AWAY indicator flashes slowly
and exit time starts. After the exit time, the AWAY indicator
is lit and all areas are displayed as armed.
Arming all areas (quick arm)
4 Press and hold [#] until the system beeps twice.
P The system beeps twice, the AWAY indicator flashes slowly
and exit time starts. After the exit time, the AWAY indicator
is lit and all areas are displayed as armed.
Arming a single area (direct AWAY arm)
Arming a single area with a master keypad is only possible for
users with the permission level master 1 or master 2.
4 Enter your code, press the 2-digit area number of the area
to be armed and press [#].
P The AWAY indicator flashes slowly and exit time starts.
After the exit time, the AWAY indicator is lit and the
selected area is displayed as armed.
4 Repeat if you want to arm multiple areas.
To enable/disable this function contact your installer.
Telephone remote arming
Notice!
Telephone remote arming is only possible when the system has
only one assigned area.
Users can use a telephone to arm the system.
1. Dial the control panel number.
The control panel answers the call and issues a long beep.
2. Press [#].
P When the panel receives the signal it confirms the arming of
the control panel with a high tone.
To enable/disable this function contact your installer.
20 en | Arming and disarming areas AMAX panel
2017.04 | 07 | F.01U.295.569 Bosch Sicherheitssysteme GmbH
To Next Page
Loading...
