P The STAY indicator flashes slowly and exit time starts. After
the exit time, the STAY indicator is lit.
To enable/disable this function contact your installer.
Forced arming
Arming areas when a zone is not sealed is known as forced
arming.
If the AWAY indicator is not lit and a long beep sounds when you
attempt to arm an area in AWAY mode, then forced arming is not
permitted. In this case, you have to seal all zones or manually
isolate them before you can arm the area.
To enable/disable this function contact your installer.
Disarming areas
Disarming with a keypad
4 Enter your code and press [#].
P The system beeps twice and the AWAY or STAY indicator is
extinguished.
Disarming with a master keypad
An optional master text keypad can be added if there is more
than one assigned area on your system.
The master keypad can be used to disarm all assigned areas.
To enable/disable this function contact your installer.
Disarming all areas:
1. Enter your code and press [#].
2. The system beeps twice and the AWAY or STAY indicator is
extinguished. All areas are disarmed.
Disarming a single area (direct disarm):
4 Enter your code, press the 2-digit area number of the area
to be disarmed and press [#].
P The system beeps twice and the AWAY or STAY indicator is
extinguished. The selected area is disarmed.
4 Repeat if you want to disarm multiple single areas.
3.1.3
3.2
3.2.1
3.2.2
AMAX panel Arming and disarming areas | en 23
Bosch Sicherheitssysteme GmbH 2017.04 | 07 | F.01U.295.569
To Next Page
Loading...
