Bosch B8512G Program Entry Guide

54 en | Panel Wide Parameters Control Panel
2017.03 | 09 | F.01U.303.998 Program Entry Guide Bosch Security Systems, Inc.
3.9.6 Test Reports
Default:
Test Reports
Route Group 1 Route Group 2 Route Group 3 Route Group 4
Status Report Yes Yes Yes No
Test Report Yes Yes Yes No
Selections:
– Yes - assign this report to the Route Group.
– No - do not assign this report to the Route Group.
RPS Menu Location
Panel Wide Parameters > Report Routing > Test Reports.
3.9.7 Diagnostic Reports
Default:
Diagnostic Reports
Route Group 1 Route Group 2 Route Group 3 Route Group 4
SDI2 Device Failure Yes Yes Yes No
SDI2 Device Restoral Yes Yes Yes No
Watchdog Reset Yes Yes Yes No
Parameter Checksum Fail Yes Yes Yes No
Reboot Yes Yes Yes No
Phone Line Fail Yes Yes Yes No
Phone Line Fail Restoral Yes Yes Yes No
AC Failure Yes Yes Yes No
AC Restoral Yes Yes Yes No
Battery Missing Yes Yes Yes No
Battery Low Yes Yes Yes No
Battery Restoral Yes Yes Yes No
Route Comm Fail Yes Yes Yes No
Route Comm Restoral Yes Yes Yes No
Checksum Fail Yes Yes Yes No
Network Fail No No No No
Network Restoral No No No No
Network Condition No No No No
RF Interference Yes Yes Yes No
RF Interference Restore Yes Yes Yes No
Equipment Fail Yes Yes Yes No

Bosch B8512G Specifications

General

Model	B8512G
Category	Control Panel
Power Supply	12 VDC
Series	G Series
Areas	8
PGM Outputs on Board	8
On-board Ethernet	Yes
Wireless Support	Yes
Manufacturer	Bosch
Input Voltage	16.5 VAC
Users	500
Communication Formats	IP, GSM, PSTN
Compatibility	Compatible with Bosch detectors, keypads, and communication modules