NL Operate device
4. Start with the start/stop button l.
The time on the display shows how long the
appliance has been in operation.
Fast preheating
The Fast Preheat function allows you to shorten the
heat-up time for some heating methods.
Suitable heating methods for rapid preheating
are:
■ < 4D hot air
■ % Top and bottom heat
To obtain an even result, do not place the food and
accessories in the cooking compartment until the
rapid preheating has finished.
Set up
Make sure that you select a suitable heating method
and a set temperature of at least 100 °C. chooses.
Otherwise, the Fast preheating function cannot be
activated.
The appliance starts to heat up.
When the dish is ready, switch off the appliance with
the on/off . button .
Note: You can also set the duration and end of
operation on the device. ~"
Time functions" on page 17
1. Set heating method and temperature.
2. Tip on the field f.
The symbol is illuminated in red. A confirmation
message appears on the display.
Modify
When rapid preheating is finished, a signal sounds
and a message appears on the display. The symbol is
no longer illuminated. Place the food in the cooking
compartment.
After the start, the temperature remains in the focus. When
you move the control ring, the temperature is immediately
changed and adopted.
To change the heating time, first interrupt use with the
start/stop button l and tips you on the field!. The first
heating method appears with the corresponding
suggested
temperature. Change the heating method with the
control ring.
Note: The Duration function starts at the same time as
the rapid preheating. Do not set a time until rapid
preheating has finished.
To break down
To end the rapid preheating, tap the field again f.
The symbol is no longer illuminated.
Note: If you change the type of heating, the other
settings are also reset.
Choose heating methods directly
Certain heating methods can be selected directly via
the touch fields. This makes it even easier and faster
to set up the device.
Heating methods that can be set via Direct selection:
■ < 4D hot air
■ % Top and bottom heat
Set up
1. Touch the field with the desired heating type.
The temperature is immediately white in the focus.
2. Set the temperature with the control ring.
3. Start with the start/stop button l.
The appliance starts to heat up.
16
To Next Page
Loading...
