Dishes NL
pDishes
Set dish
You will be completely guided through the setting
process of your chosen dish.
DishesThe “AutoPilot” function allows you to prepare a wide
variety of dishes. The device chooses most settings
independently for you.
1. Tap the % field.
The first dish is in focus in white on the display.
2. Set the desired dish with the control ring.
3. Tip on the field a.
The weight is in focus in white on the display.
4. Set the weight of the food with the control ring.
The corresponding time is calculated
automatically.
5. With the start/stop button l to confirm.
A note for accessories and shelf height appears.
6. Start with the start/stop button l.
The time counts down on the display. The heating line
does not appear with the dishes.
The appliance starts to heat up.
To achieve good results, the cooking compartment
should not be too hot for the selected dishes. If this is
the case, you will receive an indication on the display.
Let the interior cool down and start again.
ahchanges in the settings
■ The cooking result depends on the quality of the
food and the nature of the moulds. For optimum
cooking results, only use undamaged food and meat
at refrigerator temperature.
The appliance chooses the optimal heating method
and time and temperature setting for you. You only
need to enter the weight. Weights cannot be set
outside the designated range. With meat dishes
where the appliance regulates the temperature
selection for you,
temperatures up to 300 °C are reached. Therefore,
make sure that you use molds that are sufficiently
heat-resistant.
For example, you will receive instructions about
shapes, the shelf height or adding liquid to meat.
Many dishes need to be turned or stirred during
cooking. This is shown on the display shortly after
the start. You will be reminded of this at the right
time by a signal. At the end of the instructions for
use you will find instructions for suitable molds and
tips and tricks for preparation.
■
A signal sounds when the cooking time has
ended. The appliance no longer heats up.
■
When the dish is ready, switch off the appliance with
the on/off . button .
check
■
After the cooking time has elapsed, you can continue
cooking some dishes if you are not yet satisfied with the
cooking result.
The display asks if you want to continue cooking. If you
want to continue cooking, touch the start/stop buttonl. A
length of time is suggested that you can change. Start with
the start/stop buttonl.
■
Note: You can check as often as you want.
Choose dish
If you are satisfied with the result, tap the % field.
On the following pages you will find the correct setting
values for the listed dishes.
Switch the device on with the on/off button ÿ from.
Dishes
Set the end time to a later time
Chicken, unstuffed
turkey breast
Roast Pork Neck Boneless
Braised Beef
Roast veal, streaky Boneless leg of
lamb, medium Roast minced meat
made from fresh minced meat
Goulash
beef roulade
One-pan dish with vegetables
With some dishes you can set the end time to a later
time. Before the start on the fields touch and use the
control ring to delay the end time.
After the start, the device goes into standby mode.
The end time cannot be changed.
Change and abort
Once started, the settings cannot be changed.
If you want to abort the process, switch the device on with
the on/off button ÿ off.With the start/stop button l you can
no longer stop the operation.
29
To Next Page
Loading...
